Cart 0

AccessoryKitOverview

Druck - ACCESSORY PACK for 1800 Series Pressure Sensors (P/N: SO1830E) - OVERVIEW
Manufactured by:  Druck

CONTAINS:

STE Box:  (P/N:  111M1641-1) Sensor Termination Box Enclosure (STE) for Druck Submersible Pressure Sensors.

SLIMLINE SINKWEIGHT, 17.5 mm Diameter:  (P/N:  DA2608-1-01) for Druck 1800 Series Submersible Pressure Level Sensors.

CABLE CLAMP:  (P/N:  192-373-01)  In many surface and ground water applications there has been no easy or cost-effective way to hold a sensor cable at the water exit point, until now. This clamp secures a sensor cable and prevents the vent tube in the sensor cable from becoming constricted.  The slide mechanism of the cable clamp makes installation an easy task.

Calibration Adaptor G1/8:  (P/N:  DA2537-1-01)
For use with the Druck 1800 Series Submersible Pressure Sensor Platform (PTX1830/1835/1840, PDCR1830/1840). 

The female side of the adaptor is M14 x 1.5 mm-Female, which screws onto the standard pressure port on an 1800 Series Submersible Pressure Sensor (with nose cone removed).  The male side of the adaptor is G1/8-Male.

 
It is an accessory for the products below:

  • Druck 1800 Series Submersible Pressure Level Sensors
  • Druck PTX 1730 Pressure Sensor (No Longer Manufactured)
  • Druck PTX1230 & PTX1235 Submersible Pressure Transmitter
  • (No Longer Manufactured)
  • Druck PTX1280 & PTX1880 Submersible Pressure Transmitter
    (No Longer Manufactured)